T70 SUPER


The bending press S.330 T70 has a electro-welded workbench, suitably shaped and dimensioned to operate with loads double those characteristic of the machine to avoid deformation.

Another characteristic is the micrometric stroke adjustment controlled by a hydraulic valve; this allows the continuous adjustment of the punch operating stroke and the highest degree of precision to obtain the desired bending angle.

The alloyed steel carriage runs on oversize guides, tempered and ground, fitted with lubrication channels and special dust scraper. Lubrication plays a fundamental role and all models are therefore equipped with a automatic pump with an electrical device indicating the oil level for the distribution of the lubricant to all vital points of the machine.

The oil-hydraulic cylinder has been designed for average pressures such as to ensure the maximum balance between machine performance and lifespan of the most sensitive machine parts. The whole system is controlled by a hydraulic power unit consisting of a tank suitably sized to avoid damaging overheating of the oil and is fitted with measuring, regulation and hydraulic flow control instruments.

simasv t70 super
Workbench dimensions820x1720 mm
Height of workbench from the ground1010 mm
Max operating pressure98 ton
Max. stroke of mobile punch330 mm
Mobile punch stroke adjustmentYES
Mobile punch advance and retrieval speed1780/2218 mm/'
Mobile punch operating speed650 mm/'
Speed selection deviceYES
Min. and max. axis base between mobile and fixed pins190/520 mm
Mobile and fixed pins - Height180 mm
Mobile and fixed pins - Diameter80 mm
Hydraulic power unit120 Lt
Slide lubricationAutomat.
Maximum required power5,5/4 Hp/Kw
Side tool shelves2
Auxiliary lateral holes on workbenchYES
Bending press dimensions - Width1400 mm
Bending press dimensions - Length1720 mm
Bending press dimensions - Height1010 mm
Weight1910 kg