T22 SCANJA HYDRA


The special structure of the T22 Scanja press makes this machine ideal for press bending, bending, punching and cutting of all types of section bars, flat bars and tubes. The positioning of the cylinder under the workbench allows freedom of action for any type of operation on the workbench, and the controls set at the front of the machine give the operator a high degree of control over the working area during the operating phases.

The workbench is manufactured in tempered and ground steel, the carriage runs on double guides with dust scraper and manual lubrication. The mobile pin moves at two speeds and the micrometric regulation of the carriage stroke is made by means of the hydraulic valve.

simasv t22 hydra
Workbench dimensions630X1100 mm
Height of workbench from the ground925 mm
Max operating pressure22 ton
Carriage stroke200 mm
Carriage speed1750 mm/'
Mobile punch operating speed470 mm/'
Speed selection deviceYES
Press bending capacity120x15 mm
Tool holding pins - Height120 mm
Tool holding pins - Diameter55 mm
Hydraulic power unit45 Lt
Maximum required power2,5/1,5 Hp/Kw
Side tool shelvesoptional
Bending press dimensions - Width630 mm
Bending press dimensions - Length1100 mm
Bending press dimensions - Height925 mm
Weight630 kg